Just-A-Falls
Pondless Waterfall Kits use our new waterfall spillways instead of
Aquafalls Filters for
easier, lower cost installation.
Build a waterfall without a pond - Ideal for businesses and homeowners
who want the sights and sounds of a waterfall but do not want the
liability or maintenance assoicated with a pond!
Just-A-Falls
kits are easy to build and easy to maintain!
The waterfall/stream portion of a Just-A-Falls system is built the same
as a normal water feature, however, the retention basin at the bottom
is much easier and faster to build than a normal pond. Since
you
simply need a reservoir to hold water in, you do not need any
decorative shape or ledges built in. Simply dig the hole,
install
liner, place vault in hole and fill with rock.
Create the Sights and Sounds of a Waterfall Without the Liability or
Maintenance of a Pond
Extra Large Kit Includes:
- 30' long stream
- 82" wide
waterfall
- 50' x 50' liner - enough for
a 10' x 12' x 3' deep reservoir with 30' left over for a
stream
- (2)
10' x 50'
underlayment
- 82" waterfall
spillway
- EasyPro Large pond
vault
- EP16000 pump - 16,000 GPH
- UVCA30 check valve assembly
- 50'' roll of 3"
flexible pipe
- WIK
installation kit
- Ships Via Freight
- 1 year warranty
Needed: To determine how big of a reservoir you will need for a custom
sized waterfall you first need to know the gallons in the
stream. Multiply length x width x .33 x 7.48 = gallons in
stream.
Next: Determining the volume in a reservoir - since the reservoir is
filled with rock, the water volume is far less than a normal
pond. Thru testing we have determined that the reservoir
holds approximately 40% water and 60% rock. To determine
water volume multiply length x width x depth x .4 x 7.48 -
gallons. The gallons in the reservoir should be double the
gallons in the stream at minimum, ideally it should be three times the
stream gallons.
